![]() ![]() I would recommend you do likewise and burn the same photo multiple times while tweaking the settings and try to dial in the perfect fit for your laser. Still not fully right but I am getting an idea what the settings do. So, my next adjustment went to max at 45%, Min at 30% same settings else ware, and got this:Ĭlose, but I didn’t like the lines above the Badger So I did one more and bumped the Min up to 28% and got this:Ĭloser yet. This is lighter then I wanted, especially at the numbers on the sides. I then adjusted to Max power of 45% min of 25%, still at 600 DPI and 50 MM/Sec and got this: This was done at a speed of 50 MM/Sec, Max power of 65%, Min power at 40% DPI at 600,Came out considerably darker then I wanted it, ![]() Your results will vary, but here are a few photos to show what I have been learning. Greyscale seams to take a lot of trial and error to dial in. I am running a 5.5 Watt LED laser modual. ![]() Have not worked with a RAMPS board at all. I am running a Mini RAMBO board and have the TTL line routed through the Z max plug. ![]()
0 Comments
Leave a Reply. |